You’ve bought your very first bushlite and may be asking yourself how do you load your bushlite…

Load your bushlite

• If you are using standard 400g candles, cut the candle in half. To make use of the bottom half of the candle, pull the tail piece of the wick out of the bottom of the candle and insert the candle upside down…turn your approximately 4 hours of light to 8 hours using both halves of the candle. It would probably be safer to perform the surgical preparation during daylight hours.
• Twist and remove the base (10)
• Twist and remove the candle holder (7) from the base, exposing the spring (8)
• Insert the candle, wick first, into the bottom end of the candle holder
• Place the spring below the candle and push the bottom end of the candle holder into the top end of the spring guide (9) and twist to lock.

Your bushlite candle lantern should always look beautiful whilst lighting up your room, tent, campsite, bar area, well basically anywhere you can think of…To ensure your bushlite candle lantern continues to look as good as new, it may require some cleaning from time to time. Below are the step by step for your bushlite candle lantern cleaning instructions.

• Allow the candle lamp to cool and the wax to harden.
• Compress all three mantle claws (4) together and lift out the complete mantle unit from which the glass (5) is easily removed.
• Vigorously rinse the heat deflector and then wipe clean with tissue paper.
• Polish the glass with tissue or newspaper soaked in spirit for stubborn stains.
• Separate the outer casing (6), the candle holder and the base and remove any excess wax.
• Soak all parts in boiling water, wipe clean and reassemble.
• All brass parts and the silver candle lamps can be polished.

Take this….

And get it looking like this again…